FAQ: Can I adjust the mounts to a custom fit?
YES: Here's a few suggestions.
Over the many years of production on this rimfire rifle / shotgun , there has been a few tolerance changes in the groove channels.
However, theres a simple solution to custom fit our adapters to your rifle.
The goal here is to allow the two screws to do the final clamping action on the mounts to secure the mount to the groove channels.
Replace the screws and tighten to around 15 or less INCH POUND. (finger snug by inserting the long end of the wrench to avoid extra leverage).
IF TOO WIDE/ LARGE where they will slide on to the rail and not tighten down securely. We will need to lower gap distance on the underside of the mount. Place each mount on a hard surface as shown below. Use a small plastic hammer or use a small non-marring piece of wood and slightest amount necessary GENTLY tap downward to tighten the clamp (as shown with the white arrow below) .Test fit on the rifle... Repeat if needed. Replace the screws and tighten to around 15 or less INCH POUND. (finger snug by inserting the long end of the wrench to avoid extra leverage).
FAQ: What rings are on the scope images?
We have used each of these with great success:
Weaver Grand Slam Weaver-Style Rings Lever Lock Rings
Warne Maxima Quick-Detachable Weaver-Style Rings
Leupold QRW Quick-Release Weaver-Style Rings